Fiamma Crystal Lid for Vent 40 (98683-101)

The genuine Fiamma replacement crystal (smoke-tinted) dome lid for the Fiamma Vent 40 × 40cm roof vent, also known as the Vent 160 or Dome Vent 160. If your lid has yellowed, cracked or been damaged by UV, hail or a low branch, it restores a weatherproof seal without replacing the whole vent unit.

Features

• Smoke-tinted translucent polycarbonate dome (Crystal), not fully clear
• Direct bolt-on replacement using the original hinge and latch fittings; typically takes around ten minutes to fit
• Overall lid size 40 × 40cm; hole size to rubber seal approx. 35cm; widest fixing point to roof approx. 45cm
• UV-stabilised polycarbonate/acrylic
• Genuine Fiamma part (part number 98683-101)

• Fits Fiamma Vent 40 x 40cm roof vent (Dome Vent 160 / Vent 160)
• Colour: Crystal (Fiamma's smoke-tinted translucent polycarbonate dome, not fully clear)
• Overall lid size: 40 x 40cm
• Hole size to rubber seal: approx. 35cm wide
• Widest fixing point to roof: approx. 45cm
• Material: UV-stabilised polycarbonate/acrylic dome
• Manufacturer part number: 98683-101

Manufacturer Part Number: 98683-101

Q: Does this include the frame or just the dome lid?
A: This is the clear dome lid only — the vent's inner/outer frame and hinge stay in place; you simply swap the old lid for this one.

Q: Will this fit my older Fiamma vent?
A: It fits the 40 x 40cm Fiamma Vent/Dome Vent 160 range. Check your existing lid's fixing hole spacing against the 35cm/45cm measurements above before ordering.